Used Plastics Injection Moulding Machines

Good News to the Plastics Industry!

Starting April 2011, We have expanded our product range and now offering complete solution to the plastics industry.

The recently added products are

1. Used Plastics Injection Moulding Machines
2. Closed Loop Servo Motor - Pump
3. Robot
4. Solid State Relay
5. Linear Scales
6. Pressure Transducers
7. Hydraulic Valves
8. Plastics Dryer
9. Honecycle dehumidifier
10. Autoloa_ Integrative Type
11. Dehumidified Drying Loader
12. Rolling Barrel Color- Mixer
13. Vertical Color Mixer
14. Plastics Granulator
15. Low Speed Granulator
16. Instant Recycling Granualator
17. Water Chiller
18. Air Chiller
19. Mould Clamps

Our Customers now get complete range of products under one roof.   We are offering Used Plastics Injection Moulding Machines also with one year on-site warranty for the troubleshooting.  All the Machines will be certified for perofrmance with good support backup. Customers can now no need go from one place to the other to get best deals.

There are lots of packages available for the customers to get best deals.  The latest Servo Motor Package come with PLC+Servo Motor at best price with two years Waranty for the PLC.

We also offer Used Plastics Injection Moulding Machines with PLC and Servo Motor fitted at our factory. This would enable to save upto 60% on the power bill.  Next time when you plan to buy a used plastic injection moulding machine then take it with PLC+Servo Package it is the best deal ever for price+performance.  Once closed loop servo motor is installed on any Used Plastics Injection Moulding Machine then it is almost  equivalent to new injection Moulding Machine. you can save power and investment by going for this option.

Our offer is the best PPR ( Price + Performance + Return on Investment) available in the market today.  In end waht you will likely to get is the new Injection Moulding Machine at the half the price.

With increasing interest rates which is slowing down the manufacturing growth, it is not advisable to invest on new Injection Moulding Machine.

When adding new machines you may some times get additional power from the Electricity Department. My Advice is Install Servo Motor for the existing Molding Machines along with the addtional Injection Mould Machines planed, then no need to get additonal power.

There will be an increase in cost of power in the near future, especially in Tamilnadu, it is better to plan now to face that situation.